4 torque tube bearings and tail control rod guides



Zeal 700's



Mechanical build is done.

The canopy rubbers are small and lock solidly onto the canopy post better than any other heli ive owned





The Rush has 0 pitch alignment hole that go through the mixing arms and frames the kit even comes with the rods to make the setup spot on

 

Wow, that was fast. love the carbon skids brother

 

For the quality that you get the Rush is a steal

 

Nice heli, pity about the choice of mains
Simon

 

and the skids are fully sick.
Simon

 

Them skids are fully sick mate.

They also raise the tail up a bit and allow it to sit properly with packs in it

 

I heard it sits nice and stable without a flight pack (no dropping the tail) with those skids. The normals skids, not so much
Simon

 

No nibbles?
Simon

 

Ive been thinking of a come back bear with me

 

Updated 2nd post with more pics

 

Nice work mate, i love the way you protected your motor wires from the speedy tray. Nice

 

Great job @feral when is it flying?
Simon

 

1st thing tomorrow @simon I adont do maidens by myself ill wait till the boys are there

 

Hey feral. I hope you didn't take a photo of it RTF as in the plank community its bad Carma. Good luck for the maiden!

 

Good luck @feral with the maiden, the heli looks fantastic, so I know you will have a great day. Now aren't those zero pitch holes the absolute best things fr getting the swash level
Simon

 

Thanks @Fredo I haven't heard that before and im somewhat of a planker.

@simon they're cool mate the whole setup was within 15pts of being 100% perfect if I had 1mm smaller servo wheels it would be bang on perfect

 

Good luck with the maiden..

 

Thanks Manyc

 

Hope it all goes well for you @feral. Better get a video done somewhere in the first few flights so we can check out your new toy.


Citizen #186