New Sab Goblin 380 Swash Leveling Tool / Partial Fail!

Discussion in 'SAB' started by The Dude, May 19, 2015.

By The Dude on May 19, 2015 at 2:42 PM
  1. The Dude

    The Dude Well-Known Member

    Joined:
    Mar 4, 2014
    Messages:
    1,070
    Likes Received:
    650
    Great for a quick setup but not much good for doing high and low leveling on the swash !

     

Comments

Discussion in 'SAB' started by The Dude, May 19, 2015.

    1. Kyle Orrock

      Kyle Orrock New Member

      Joined:
      May 20, 2015
      Messages:
      16
      Likes Received:
      18
      To be honest with the 380 there is no need to do a high and low level if u are using arm of the correct length and a good FBL unit it will compensate for the tiny amount it could be out


      Sent from my iPhone using Tapatalk
       
    2. The Dude

      The Dude Well-Known Member

      Joined:
      Mar 4, 2014
      Messages:
      1,070
      Likes Received:
      650
      True, if a good FBL unit it will compensate for it, then we don't need to be very fussy with leveling the swash at all.. However i personally like my setups to be spot on for top and bottom, it makes a difference, especially on the smaller heli's ...
       
      Last edited: May 20, 2015
    3. 3dmick

      3dmick Well-Known Member

      Joined:
      Mar 14, 2014
      Messages:
      1,050
      Likes Received:
      983
      I just used a bearing that fits on the main shaft works fine
       
      • Like Like x 1
      • Informative Informative x 1
      • List

Share This Page

test

    About Us

    Just like you, Heligods staff are regular everyday fliers. Join our forum and participate in what will become the worlds greatest rc helicopter forum..

    Credits:

    A big thank you to the following people who helped us put together this site:

    Pope Francis

    Deli Lama

    George Bush

    Gene Simmons (aka Crash)